Keith is correct in that the command syntax is simple enough to roll
your own routines.
There is a "universal" library that gives common function calls for a
variety of transceivers, Omnirig, available at
http://www.dxatlas.com/omnirig/
I looked at this when writing Z90 Control version 2 to allow the Z90/91
panadapter to interface with other than K2 transceivers, but decided
that my Z90 customer base was so heavily weighted to the K2 that the
extra effort required to use Omnirig was not justified. Instead, I just
wrote a few simple Delphi routines to read and write the necessary commands.
Jack K8ZOA
Darwin, Keith wrote:
I haven't looked at the set of commands to control the K2 over serial.
I seem to recall they're somewhere, right? Is it just a simple command
/ response protocol? Does the K2 send any spontaneous messages to the
controller? It is probably simple enough that I'd be inclined to write
my own rather than looking for one, but that's just me.
- Keith N1AS -
- K2 5411.ssb.100 -
-----Original Message-----
From: Tom Zeltwanger
Can anybody recommend a source of any open source software or libraries
(preferably "C" language) for talking to my K2? I just build the KIO2
and am looking at doing some custom interface programming.
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
