Mike,
If the KDSP2 seems to be working properly, I must ask about the
possibility of the LED being reversed.
Shine a light on the top of the KDSP2 and look carefully at the LED -
near the base you will find some reflective metal through the colored
lens - there is a narrow wedge in that metal. If the wedge points
toward the connector, the LED is mounted correctly, but if it points
toward the edge of the board, it is mounted backwards.
73,
Don W3FPR
Mike Geddes wrote:
Installed the KDSP2 module in my K2 this morning. During initial
checkout, the LED light does not come on upon power up, or at any other
time. The other steps on the initial checkout (p.18) seem to be working
as specified. What does it mean when the LED does not come on? Is there
any particular thing I should be checking or looking for? Is it
possible that the module is defective? I double checked the connections
to make sure the KDSP2 board was inserted into the control board jumpers
correctly, and that the DSPx module was inserted in the KDSP2 board
correctly.
Any suggestions are appreciated.
Tnx and 73,
Mike
N4JX
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
