Bryan,
For some reason or another, the AUXBUS signal is not getting from the
KIOC chip (RF BOARD U1) to the Control Board microprocessor. That is
indicated both by the INFO 080 message and the 255 in the display
instead of the KIOC chip level. Check the voltage at each of the pins
on U1 using the DC Voltage Chart in the back of the manual.
Also check the resistance through the AUXBUS path from RF Board U1 pin
28 to Control Board U6 pin 40 - there are 2 100 ohm resistors in that
path plus connectors and PC board traces, so you should find a
resistance just a bit above 200 ohms. There should also be a high
resistance from the AUXBUS line to ground. If you find the resistances
are not proper, look for the unsoldered connection or the solder bridge
at all points along the AUXBUS path (including the Control Board to RF
Board connectors).
Be certain RF Board U1 is seated fully into its socket and that there
are no pins bent under the chip body.
73,
Don W3FPR
Bryan wrote:
Hi
I have got to page 42, and I have a problem. Switching on I get the INFO 080
message. Pushing DISPLAY gives me the message 2.04p 255 for a few secs. Then I
get a frequency readout. Of course I have checked my soldering several times,
and I've changed U1, and even tried a known good Control board. Has anyone
seen this problem before.
73, Bryan GM3AKF
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
