Hi!
I just finished the KPA100. All the tests were great. Final assembly was
fine. I hooked it up to my antenna through my SGC MAC-200. Hit the tune
button, the tuner started doing it's thing, and then the radio just up and
died. The basic K2 with SSB, DSP, 60 and 160 mtr options had been working
fine up to this point.
I tried to use the barrel connector for power, but get nothing there
either. I do get a slight pop from the speaker when the power is connected
to the power pole connectors when I switch the radio on, but nothing else
comes on. No lights, sounds, etc.
I will pull the PA cover off in the morning and see if going with the QRP
cover will make a difference and also check for things that don't look
right. However, I didn't see or smell any smoke.
Thanks for any help
Jim, WD9HBC
K2 #5757
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
