On Apr 29, 2007, at 1:17 PM, Richard Thorne wrote:
After listening to the BS7H pile on 20m's today I was reminded that
the receiver in my 480 is not all that great. Even with the 500hz
crystal filter installed, there were all kinds of artifacts from
strong stations transmitting up a few khz. So the K3 has grabbed my
attention. A couple of questions that are key to remote operations:
1 - I understand that if I short two pins from the ACC connector on
the back I can turn the rig on/off. When shorting those two pins is
it momentary or constant.
Momentary (at least 0.5 second). Or you can leave it on permanently, at
least until you want to turn the rig off.
IE if I can turn a relay on and off remotely will that relay need to
stay engaged to keep the rig on? A little more info would be helpful.
I would rather the rig could be turned on with a software command or
the wake on serial suggestion made earlier.
I can't guarantee this right now, but it's on the list.
2 - I use the sound card on my pc to send receive audio over the
internet. Can I send ssb via the pc mono in on the back of the rig.
I would assume so since psk is done in ssb.
Yes.
73,
Wayne
N6KR
---
http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
