If you activate the RIT/XIT, I am guessing that you can monitor that
as an option in the VFO B display. But...does it show the frequency
or the amount of offset (or can you select that too)? I'm hoping one
can see the offset in KHz (+/- 0.00).
When you activate RIT there is an RIT icon in between the VFO A and VFO
B displays that becomes visible.
The VFO A display (assuming you are receiving on VFO A) shows the new
operating frequency. The B display shows the amount of offset. After a
couple of seconds of no further RIT know turning, the B display reverts
to whatever it was displaying before you turned the RIT knob.
If you subsequently turn the RIT knob, the B display agins shows the
amount of offset until a second or two after you stop turning it.
I "get" the center "detent" LED, but what are the other for (at each
end)? End of range?
No, just reminders that you are both enabled and offset.
73,
Lyle KK7P
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
