[EMAIL PROTECTED] wrote:
Does K3 have a variable delay (0-50ms) to control older amps TX relays
(ie; SB-220, L4B, etc)?
Yes. It also has a separate PTT input jack, so you can pre-switch the
amp using a footswitch, etc.
What is voltage/current limit to control TX amp relays (ie; SB-220,
L4B, etc)?
The keying device is rated at 200 volts, 6 amps.
If using an external receiver with K3 is the RX ANT OUT the correct
connection to get signal to the external RX?
If you have an external receiver connected to RX ANT OUT, it will get
RF from the K3's main antenna jack *if* you turn RX ANT on (K3 front
panel switch). This is very useful, because it allows you to A/B test
the K3 against a second receiver at the tap of a switch.
73,
Wayne
N6KR
---
http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
