Great Don. Thanks!
73,
Mike
N4JX
----- Original Message -----
From: "Don Wilhelm" <[EMAIL PROTECTED]>
To: "Mike Geddes" <[EMAIL PROTECTED]>
Sent: Monday, May 07, 2007 7:23 PM
Subject: Re: [Elecraft] TenTec 701 Hand Mike wiring
Mike,
You are correct - wire the Yellow lead to pin 1, Black to pin 2, Braid
to pin 7 and Red to pin 6.
You do not need any resistor on the mic jack, but if you already have a
5.6k mounted between pins 1 and 6 (so the Elecraft mics will work), the
TenTec mike will work fine with it installed.
73,
Don W3FPR
Mike Geddes wrote:
Greetings Elecrafters! Just received my TenTec 701 hand mike in the
mail today, for use with my K2. I am going to jumper the K2 straight
across (the Elecraft mode), and rewire the 701 to fit it. Can anyone
confirm the wiring on the 701? I think it is:
Braid - Ground
Black - PTT
Red - Power
Yellow - Microphone
Please confirm if you are able. Thanks in advance.
73,
Mike
N4JX
K1/4 2319
K2 6042
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
