Allan,
Was that J5, the 3 pin connector point (no header is normally installed
there) on the RF Board near the front center (near the control board)?
If you did everything correctly, it should have no effect on the K2
power-up condition. If you wired to some other place than the 3 pin J5,
remove what you added and try to discover what the error is.
It may have been something that inadvertently happened, and not at all
associated with your additions - in that case, voltage measurements are
in order. You may have had a pin pushed back on the AUX DC connector
from the KPA100, and it is no longer making contact with P3 on the RF
Board - insert the crimp pins into the housing correctly if you find
that to be the problem.
Is the KPA100 ribbon cable properly attached to the control board?
These are but a few starter questions.
73,
Don W3FPR
Allan Bacon wrote:
K2 4670 with 100W and all options was working fine.
Per the recommendation of Microham, I added a speaker jack from J5 to a
stereo plug on the back of the case and now the unit will not power up on
the KPA-100
When I plug in power to the low power jack, the unit is OK, but will not go
to high power.
Any ideas?
Thanks,
73,
Allan Bacon
W6GBG
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
