Hello all. First time build of a K1 and I could use some advice on installing the switches. The pins I have sit a bit narrower than the pin holes on the circuit board. Slight pressure separates them sufficiently to fit the holes, but they do not want to extend through the holes, they extend just far enough to fill the hole but not quite far enough to break through the plane of the board on the side opposite the switch. "Switch pins are fragile" keeps me from applying too much force worrying about bending the pins, and I did manage to create a 90 degree bend in one.
Am I missing a trick? NU6T Rich _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
