On Jun 7, 2007, at 10:35 AM, wayne burdick wrote:
I think this gets back to my comment about resolution. If you are
using a quantized bar-graph display it is easier to change the
calibration than to change the resolution. OTOH, three digits
would be nice or even an analog meter. (I actually still prefer
analog meters for a lot of things, especially doing calibrations
involving tweaking things.)
I just added a task to my future-K3-firmware list: allow the VFO B
display to optionally show signal level in dBm. Three digits. Just
for you, Brian :)
<sitting here with jaw hanging open> Wow. Uh, thanks!
73 de Brian, WB6RQN
Brian Lloyd - brian HYPHEN wb6rqn AT lloyd DOT com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
