Phil,
It sounds like you have either the frequency offset or the IF frequency
currently set to 14.000 MHz - something to check out. Look at all the
parameters for the TRN3 entry and you will find one of them incorrect.
The IF frequency should be 28 MHz.
73,
Don W3FPR
Phillip Buckholdt wrote:
Hi all
I am using a XV-50 and XV-144. I am now finishing a Xv-432. When
setting up in the K-2 menu as TRN3, setting the operating freq. as 432
and exiting the menu, then going to TRN3 the dispayed frequency is
418.000. To get the K-2 display to read 432.000, I have to set the
Freq. to 446 in the setup menu. Is this right?? Can't find any
reference to this in the K-2, XV60 or XV432 manuals.
Does anyone have had this problem?
Thanks de Phil
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
