Hi Martin:
At 07:57 06/12/2007, Don Wilhelm wrote:
I would strongly suggest using the 8R signal instead - when inverted
it is the same as the signal from the KPA100 ext amp keying
interface or the Amp Keying interface for the base K2 that is
offered by Tom N0SS.
See: http://www.n0ss.net/k2_t-r_rly_drvr.pdf
73,
Tom N0SS
8R can be set to a delay in the K2 menu and is present about 15ms
prior to the onset of RF, 8T cannot be manipulated by the menu parameters.
The amp keying interface grounds when active, but you could drive a
small (fast) relay that will in turn provide your required voltage.
73,
Don W3FPR
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
