Hi the gang,
Att Gary!
I was going to test the new KAT100. A moment before, it was all right with
all checks, the bridge balanced nicely. I was doing this test without the
KPA100, directly at the K2 output without KAT2.
No reactions from KAT100 (no led on, no detection bye ATU menu). Wth 5 w on
power level, the output is more than 20 w, with I>4.50 A. Tx off, power to
0, tune on output 20w for a few second then down to 0. tx off power max,
tune on, output >20w, but no control with power level.
Back to basic K2, withpout KAT100 or KAT2, same results. In this conditions,
VREFDET around 1.3 v.
If power =0 then VREFDET = 0.
Well I,m lost once more. The KPA100 is running OK. The KPA100 look OK with
resistances check.
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
