>I don't have the frequency counter test cable mentioned in the CAL FIL >section, at least I don't think I do.
You need the counter probe to adjust the filters and it needs to be connected. Check it's not inside the K2 - it's a short piece of coax with a two pin header on one end and a single pin connector on the other. The procedure is in the manual which you can download if you don't have it. >The coax is connected to the ANTENNA BNC instead of ANT1 or ANT2. You must use ANT1 or ANT2 if the ATU is in place >I might want to use the KAT2 in the field and KPA100 at home. It takes about 2 minutes to swap the KPA100 for the QRP top cover. All connections are plug/sockets Hope this helps. Regards, Paul M1PAF _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
