Here's the technique I used to install C56, which has no solder pads and must
be soldered to two pins on relay K1 instead.
After shaping the leads of C56 to have the correct spacing, I left them intact
and straight. I then slid the two leads underneath L7 and positioned c56 next
to pins 2 and 3 on K1. Sliding the leads under L7 pinned C56 down so that I
could solder it to pins 2 and 3 on K1 without it moving. After C56 was
successfully soldered in place, I then cut the two leads and removed them from
under L7.
Steve Westfall
____________________________________________________________________________________
Be a better Heartthrob. Get better relationship answers from someone who knows.
Yahoo! Answers - Check it out.
http://answers.yahoo.com/dir/?link=list&sid=396545433
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
