Hi All
Up to Alignment test (p 60) onto the VCO test. So far all resistance
checks and previous tests check out within tolerance. Freq probe has
been replaced with known good one too.
Problem - with Freq counter in tp1 I should see 8-10 Mhz with freq on
about 4000.1khz. I do not. Display shows 00000Khz steady. Have re
checked and heated all connections, replaced Q17 (just in case) but
reading does not change.
Any pointers?
Thanks M0RGB Gary
--
Ian J Maude G0VGS
SysOp GB7MBC DX Cluster
Member of RSGB, ARRL, GQRP
K2 #4044 | K3 #?
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
