Dave,
I suspect you also have the KDSP2 installed.
Try increasing the setting of T-R delay. Also EDIT the T-R parameter
and push DISPLAY to toggle between 8R NOR and 8R HOLD - use the one that
reduces the pop better.
The situation is apparently caused by the delay through the KDSP2 which
modifies the mute timing and causes a pop on unmute. There is some (yet
undefined to me) influence from the KPA100 T/R switching. If you have
an older KPA100 (before Nov 2006) adding the KPA100UPKT to your KPA100
may help. Why this appears on some K2 and not others is an additional
mystery I have not yet figured out.
73,
Don W3FPR
David Walker wrote:
Hi all,
I've just noticed a pop between RX and TX with the KPA installed and the
power above 11w. Set below 11w all is fine. There is something on the
AC6RM website about this but I can't access it.
Could someone clue me on how to resolve this?
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
