Note that the rear panel microphone connector is a 3.5mm mono phone jack whereas the front panel connector is the standard 8-pin microphone jack. Only one connector can be enabled at a time and bias can be selected, or not, to that active connector. Any microphone plugged into the unselected jack is invisible to the radio.
73, Ed - W0YK > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] On Behalf Of Don Wilhelm > Sent: Tuesday, 24 July, 2007 08:42 > To: Edward Dickinson III > Cc: 'elecraft' > Subject: Re: [Elecraft] K3 Mic Pinout > > Dick, > > It is the same as the 'Elecraft' mic pinout shown in the KSB2 manual. > You can download it from the Elecraft website if you don't > have a copy. > > The bias resistor can be switched in or out via menu selections. > > IIRC, the front and back panel jacks can be independent (one > with bias set on, one without). > > 73, > Don W3FPR > > Edward Dickinson III wrote: > > Does someone have a cut and paste copy of the K3 mic pinout > that they > > can post? > _______________________________________________ > Elecraft mailing list > Post to: [email protected] > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com > _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
