When I put the voltage regulators on the control board, I first mounted
them upside down so that I could judge the best place to bend the leads.
When I reached the driver transistor, there were two many components
in the way, with the result that I didn't get the optimum position.
Could I suggest that the assembly instructions either specify forming
the leads whilst the board is still clear, or that a 1:1 scale template
is included.
--
David Woolley
Emails are not formal business letters, whatever businesses may want.
RFC1855 says there should be an address here, but, in a world of spam,
that is no longer good advice, as archive address hiding may not work.
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
