Today I tried scanning for the first time with surprising results. Instead of staying on a signal for about 25 seconds, my K2 stays on a signal for a random 3 to 18 seconds (usually less than 5 seconds). These CW stations heard by scanning are often very strong and over 15 wpm with no breaks in transmission expected. The random nature of the pause time with good signals is also a surprise.
I setup the scanning with DSP on and off with no difference in results. The scan rate was also varied with no differences observed. Does the procedure you have followed give the 25 second result described in the manual? Any ideas of why the K2 #6155 with 2.04P firmware might act this way? 73 -- Arthur [EMAIL PROTECTED] [EMAIL PROTECTED] (files >5Mb) _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
