Denis,
Not to worrk about how it is marked - it is reversible, so if it mounts
on the board at all, it will be correct. - you cannot get it wrong.
73,
Don W3FPR
Denis Jackson wrote:
Hi chaps,
Just building the front panel board on my k2 ser. 6160.
All was going swimmingly until I came to fit the backlight. The pins of the diodes on the
backlight are labled A and K and the board has + and - indicated for each. I would assume that
"k" on the backlight should go into the "+" hole on the board. Before I do
what seems logical, I'm hoping somone can confirm.
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
