Carsten,
The K3's internal keyer presently has two iambic keying modes, A and B,
which closely emulate Curtis mode A and Super CMOS II mode B
respectively.
Mode A, which I use, is the default. (I think it's less error prone
than mode B, but say this in a crowed bar and you'll start a fight for
sure.) Some operators like mode B for its
element-insertion-on-squeeze-release, either because it permits faster
keying or because they learned using a mode-B keyer.
We plan to allow for turning the dot/dash memories off completely in a
future firmware revision.
73,
Wayne
N6KR
On Sep 7, 2007, at 8:15 AM, Carsten Steinhöfel wrote:
Hi there,
I haven't found anything in the archives or the FAQ. I have a question
regarding the keyer in the K3. Which keying "mode" does it use? If it
has a dot/dash-memory, can that be switched off?
---
http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
