Larry,
This is a frequently asked question - and it occurs when the 8 volt
supply rail is on the low side of its tolerance range. If you cannot
get it up to 3.8, then leave it set at the highest setting.
73,
Don W3FPR
Larry Naumann wrote:
I am building a K2 and when I try to adjust the AGC voltage the most I can get
is just under 3.8 volts, about 3.7 is what I can get. Is this okay or do I have
a problem somehwere?
Thanks
Larry
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
