Greetings folks,
If I may interrupt the K3 threads for just a moment...
My K2 SN 4912 developed a fault sometime between last evening and
this evening! Upon jumping to the shack to
have a few relaxing QSO's before bed I was greeted by an INFO 080. I
figured I'd start by checking pins of RFU1 as in the
manual and pulled the KPA. I fired it up without the KPA, and,
problem disappears.
Casual inspection of the KPA shows no fault, searching the list turns
up no clues, and finally the KPA manual refers INFO 080 back to the
K2 manual.
If I had to guess, I'd say auxbus short.
With only the KPA connected (nothing external to the AUX RS232) fault
remains. Where should I start digging in the KPA?
73,
Joe, KC0VKN
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
