Thanks Chris and here is the answer
What is the microphone pin-out on the K3?
The K3 8-pin microphone connector is wired the same as the K2 using the
Kenwood pin-out. Plus we added a lot more mic pre-amp gain (adjustable) in
the K3. There's also a 1/8-inch mono mic connector on the rear panel. This
helps with keeping the clutter down during the heat of a contest. The mic
source is set from a menu option.
de WP4o, Ed
----- Original Message -----
From: "G3SJJ" <[EMAIL PROTECTED]>
Cc: <[email protected]>
Sent: Wednesday, September 26, 2007 8:48 AM
Subject: Re: [Elecraft] mic pin config for the k3 microphone(what Mic r
theFT'susing)
http://www.elecraft.com/K3/K3FAQ.htm#mic%20wiring
Chris G3SJJ
Ed Rodriguez wrote:
Sorry for the dumb question, but what configuration is the mic pin for
the K3 , ie; Kenwood 8 pin? what microphones are the field testers
using? what do you all recommend to use, Elecraft is selling the Hand
Mic, how does that preform?
thanks, De Wp4o Tampa, Fl awaiting for the 3rd wave of the K3,
current rig Kenwood TS 950SDX.
ED
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
