Hi All,
Just acquired my very first amp (Acom 1K) and intend hanging it off the
back of my K3 in due course. According to my reading of the manual there
is just a Key-Out line for switching an amp but no input back from the
amp to inhibit the K3 tx until the amp is ready ('ground when ready', TX
Inhibit etc...)
So was wondering if I'd missed something here and also was wondering if
there is a variable delay function to adjust the timing between Key Out
switching the amp and the K3 squirting out RF? Using a FT990 at the
moment which has a TXInhibit function though apparently the timing even
then is a bit tight for some amps' relays. As I said, it's my first amp
so virtually no experience at interfacing these things and don't want
fireworks, bonfires or welded relays with a new amp *and* new K3...!
73,
Stewart Rolfe, GW0ETF
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
