I think this might be on the cards - I too would like to do this to tune my SGC at as low a power as possible (without having to reduce my RF and key, then turn RF up again).
On 17/10/07 17:45, "Joe Subich, W4TV" <[EMAIL PROTECTED]> sent: > > The K3 ACC connector appears to provide Band Data and PTT > out signals suitable for driving/Controlling the Yaesu Quadra > (VL-1000) amplifier. Is it possible to program one of the > "DIG" signal lines (other than DIG0 which is used for FSK > input) to work with the Quadra's "F-SET" output? > > F-SET is a relay contact that places the Yaesu transceiver > in CW Keydown and a specific power level (e.g., 10 watts) > for tuning the Quadra's antenna tuner. It would be very > handy to be able to access a low power tune output for other > uses - manual tuners, etc. - in addition automatic operation > with the Quadra/VL-1000. > > 73, -- A bit of fragrance always clings to the hand that gives the rose. -Chinese proverb _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
