I'm performing the Bridge Null Adjustment (C55) on my KAT2, but can't get it below 012. It is clear when adjusting C55 that I _AM_ centered in the middle of a "dip". However, I can only get the value to go down to 012. Per the manual, I've checked T1's windings and their continuity and have checked the continuity and arrangement of the cable wires (J7 and J8) -- I don't see any problems.
Is a minimum value of 012 "good enough", or do I need to look more closely at the SWR bridge components? How might the operation of the KAT2 be affected by this "higher than normal" value? Thanks, Michael N9BDF K2 #4137 _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
