I was a little concerned after installation of the Noise blanker board as it did not sit level to the RF board. I thought that the standoff I had installed was a little short. Measuring it, it was correct as per the manual. . . I added a third split ring washer to the assembly sotherre are now two on top side of the board, raising the spacer just enough to level it out. Al WA6VNN sn31
************************************** See what's new at http://www.aol.com _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
