> When doing the TX gain calibration (page 46/47 of the Owner's Manual): > > 1) Does TECH MD have to be on or off? I assume on.
No. All TECH MD does is allow you to view more parameters in the CONFIG menu, but that is irrelevant to this calibration procedure. > 2) Does one need to be in the TXGN menu? No. > 3) Set Power to exactly 5/50/.001 watts somewhere in the K3 > display or adjust power until the reading on the external > (hopefully) accurate RF power meter is 5/50/.001 watts? And > then check the reading on the VFO-B display? Turn the POWER control to set power at 5 or 50 watts. Hold TUNE and let it run for 1-2 seconds (until the power display settles). > 4) Go to next band and repeat 3... Yes. 73, Ed - W0YK _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
