Werner,
The new T/R switch design eliminates RFC10. It was a source of trouble
because it could cause a 40 meter parasitic oscillation. That problem
was usually noticed when operating with a KAT100.
Do not install RFC10 in the updated KPA100.
73,
Don W3FPR
Dr. Werner Furlan wrote:
hello,
in my KPA 100 manual there is RFC 10 from the center pin of J2 to the
Ground pin. It is no more present in the Rev. E manual. Should I install it or
not?
I plan to mount the KPA 100 on top of the Kat100 in the EC2 housing.
73!
Werner
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
