I appreciate all the help on getting the pads to stick better on the KXB30 board. I took care of that and the saga continues. I need just a bit more help.
I put the pads on the board and put the radio back together as instructed. Hooked up the DMM in series with the power and turned it on. No lights. Checked the in-line fuse and it was blown. I was not sure if I blew it as a part of this...or earlier. After not finding any more fuses lying around I ran off to Radio Shack before they closed. Came back and ran the test with a few fuse...still no lights. The install looked good but the manual indicates that this probably means a short. I decdided that maybe I did not get the board in the exact spot it was supposed to be in and that was causing the short or maybe I did something to them rest of the radio while installing. So...I clipped all the leads and took the board out and then de-soldered all the connections on the board and on the rest of the radio. (At least I now have a decent technique for using solder wick). I put the radio back together how it was before the adventure began and.....no lights!!!! Uh oh. While looking at it I remembered that the shoulder washer that is installed with the power amplifier transitor had come out during all of this but I had put it back in. I was sure that it was to keep the transistor from touching the outer case. I decided to doublecheck the manual.....and of course I was wrong. It goes between the standoff the the transitor. Ugh. Switch it around and put the radio back together...and I have lights!! But the 30M board is still sitting here and it might have worked if I had put that shoulder washer back in right the first time. So...now to my question. Elecraft provides a short piece of solid, insulated hookup wire that is used to fashion the leads to connect the board to the radio. I only have enough left to make the two short insulated wires (D and 5 I believe) but not the other 5 non-insulated leads that are needed. What is acceptable to use? I have all kinds of other hookup wire but a lot of it is stranded not solid. I have some that is copper and solid. Any advice on what to use? I can tell they use this hookup wire for the leads as it need to be a bit flexible to reach from the board to the holes where it is soldered. Thanks...and 73 de Keith KB3ILS _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
