Dave G4AON <[EMAIL PROTECTED]> wrote:
I've just tried to scan the beacon end of 50 MHz and my K3 reports that
scanning isn't allowed on this band!
Er, can we have that one fixed?
-----------------------------------------------------------------------
Thanks for posting the results your measurements of your K3's noise floor on
50 MHz. I hope that that the K3 will be fixed to allow scanning chosen parts
of the 50 MHz band, as well as frequencies a few hundred kHz below the band.
Am I right to assume that the K3's receiver can be tuned below the band, at
least to the frequency where the front end filters start to roll off?
73,
Geoff
GM4ESD
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
