here I am again with my next question. I don't understand how the fan should work in my KPA100. I have set the fan to normal in the K2 PA menue. Like this it is off when I switch the amplifier on. It goes to fast when I operate for a certain time with high power and the heatsink gets hot. But I did not see a low speed operation of the fan in this mode.
When I switch to low/high, it always runs at low speed and probably switches to high when necessary. Is it correct that there is only one temperature trigger point? >From reading the bias setting part of the manual, I thought the fan should run at low speed also when I switch the PA into high power mode. Is it correct how it works here? 73! de Werner OE9FWV -- Sleep is a poor subsititue for caffeine.-- Pat Dughi Email powered by Pegasus Mail free at <http://www.pmail.com> Homepage: <http://www.qsl.net/oe9fwv/> Fone +43 5522 75013 Fax +43 820 555 85 2621 Mobile +43 664 6340014 Elecraft K2 #5203 _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
