Chris,
If your K2 does receive, there must have been something installed in
place of the noise blanker.
Normally, without the KNB2 installed, R88, R89 and R90 serve as a 6 dB
pad following the post mixer amplifier. If the 6 dB pad is not
installed (such as a simple jumper installed), the receiver would
function, but the termination of the post-mixer amplifier and IF filter
input would not be correct, so the dynamic range and IMD could be
compromised. Check to see if there is that 6 dB pad connected anywhere
in the vicinity of the KNB2 loaction - if it is not, then restore the
original resistors.
73,
Don W3FPR
Hans-Christoph Scheiblberger wrote:
I bought my K2 on the used market and I realized that the previous owner had
removed the Noise Blanker and W5, R88,R89 and R90 were not reinstalled.Does
this affect rx performance?Should I install these parts again?
73, Chris
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
