Buck. Please report issues such as this to the [EMAIL PROTECTED] address that was included with the radio.
I'll pass this on to our software person who designed the downloader. This must be associated with the new downloader as I've not seen this reported before. The issue of Line-In staing active through a power cycle has already been identified and was corrected today. It will be available in the next FW update. Thanks. 73 Greg AB7R -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] Behalf Of [EMAIL PROTECTED] Sent: Monday, December 03, 2007 6:54 PM To: [email protected] Subject: [Elecraft] K3 problem with logging program after download upgrade The downloader utility did not reset the baud rate back from the 38,400 for the download to the 4800 specified for the rig control - I know I read somewhere it was supposed to do this. As a result my logging program stopped responding to the radio. I reset the logging program to accept 38,400 and now the DxLab and the K3 are talking to each other again. Also, the Mic Sel of Line In stopped working. Once I cycled through the other choices back to Line In, it started working again. Craig "Buck" k4ia Fredericksburg, Virginia USA **************************************Check out AOL's list of 2007's hottest products. (http://money.aol.com/special/hot-products-2007?NCID=aoltop00030000000001) _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
