> Can you explain the note that says "!!Must be used with MH2
> MG2 or Proset-K2?"
It means that the cables (and microHAM interfaces for Elecraft)
must be used with radios and microphones wired according to the
"Kenwood" standard. The original K2 had programmable mic jumpers
and the Elecraft cable sets would only work when the mic/radio
were wired for the MH2, MG2 or Proset-K2.
The K3 is "hard wired" for Kenwood style mics - the considerations
are the same. OEM microphones (MH2, Proset-k2) or identically
wired microphones must be used with the microham interfaces.
73,
... Joe Subich, W4TV
microHAM America
http://www.microHAM-USA.com
http://groups.yahoo.com/group/microHAM
[EMAIL PROTECTED]
> -----Original Message-----
> From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]
> Sent: Wednesday, December 05, 2007 9:21 PM
> To: [EMAIL PROTECTED]; [email protected]
> Subject: Re: [Elecraft] microHAM K3 cables ...
>
>
> Joe -
>
> Can you explain the note that says "!!Must be used with MH2
> MG2 or Proset-K2?"
>
> Does this mean I can not use it with the Heil Goldline with
> the dual elements?
>
> k4ia
> Craig "Buck"
> Fredericksburg, Virginia USA
>
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
