the new 10 watt lpa....
Not that I plan on taking the bottom off frequently,
It's ALOT BETTER AND EASIER THAN THE K2,,,,
......and as I did it could only think of the k2's lpa procedure,,,,,
bill #44
While we're talking disassembly, let me point out that Wayne specifically
avoided needing thermal pads or complicated hardware stacks anywhere on the
K3 bottom cover assembly even though the rear section is the heat sink for
the 10-watt low power amplifier (LPA) module. Pulling the bottom covers is
simply a matter of removing screws and lifting the covers off. Reinstalling
the covers involves setting them in place and putting all the screws back
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
