Here is some useful info if you should see ERR TXF show up after you
download 1.48/1.45.
----- Original Message -----
From: "Gary Surrency" <[EMAIL PROTECTED]>
To: "Gary Bartlett VE1RGB" <[EMAIL PROTECTED]>
Sent: Thursday, December 13, 2007 9:33 PM
Subject: VE1RGB Re: Lost TX with latest FW!!!
Hi Gary,
Just go back into the filter menus and be sure everything is set to the
correct filter. See pages 43-44. The last f/w upgrade set defaults for the
filters which may not agree with how you have installed the filters in
your K3.
Be sure and do all modes for FLTX to a filter such as 2.7 or 2.8kHz -
whichever one your K3 has.
You might want to redo the TX gain calibration again too, on pages 46- 47
of the K3 Owner's manual.
If not done, also do the REF CAL setup, using Method #2 as Method #3 is
not implement yet if you have the 1ppm TXCO.
Hope this gets it going! :-)
--
73, Gary AB7MY
=========
[EMAIL PROTECTED]
Elecraft Technical Support
Gary Bartlett VE1RGB wrote:
I have just downloaded 1.48/1.45 and every attempt to transmit CW on any
band leads to ERR TXF. >>
Help!!
Gary, VE1RGB
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
