-----BEGIN PGP SIGNED MESSAGE----- Hash: SHA1 I do the same.
Set the power out at 30W then switch the meter to ALC and adjust the audio level for NO ALC indication. Switch back to RF on the meter and it just flickers the third LED while transmitting. Nothing but great reports. I've got two 80mm computer case fans arranged diagonally on the heat sink drawing air through the fins up and out. A small square of double stick foam tape in each corner of both fans holds them tight. I do use the rigblaster+ interface. I have been thinking of swapping out my tired old SB Live sound card for an M-Audio Delta 44. 73 David Robertson wrote: > Stephen, > I also use my K2-100 on psk. > > I find that it is best to throttle down your power to 30 watts with the power > control, then adjust you audio drive for just 30 watts out. I also turned > audio compression off. I have received very good reports on IMD operating in > this manner. > > I know your not interested in interfaces but be advised the audio in and out > of the K2 are not isolated. If you are using a laptop computer then there > should be no problem but on my desk top system I had to isolate the input and > output audio to prevent ground loops. > > Hope this helps. > > 73 and Happy Holidays. > > Dave KD1NA - -- R. Kevin Stover, ACØH -----BEGIN PGP SIGNATURE----- Version: GnuPG v1.4.7 (MingW32) Comment: Using GnuPG with Mozilla - http://enigmail.mozdev.org iD8DBQFHZCu311jxjloa2wsRAlZmAJ9R0ZrlrwS3fFyYaqkHPH2TALUZaACfTpBk lbCzMJr+JjjmaVT9lrocoIA= =zNSa -----END PGP SIGNATURE----- _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
