Tom,
Have the SSB filters been set up properly - it sounds like they have not.
Is the KSB2 option installed? If, so, SSB FL1 must be set to OP1, 2, 3,
4 or 5.
If you are not familiar with the K2 filter alignment procedures, there
is information on the Elecraft website for how to use Spectrogram to
assist with that task. There is also information about setting the
filters on my website http://w3fpr.qrpradio.com in part 3 of the article
on K2 Dial Calibration.
73,
Don W3FPR
tpotts wrote:
I am trying to receive on an early K2, and it has been several years since I
have used one. For some reason, I can only copy ssb when c mode is
displayed?? When displayed U and L are fairly quite and signals other than
code are unintelligible. Could this be a set up issue, or something really
stupid on my part??? Any suggestions would be greatly appreciated. Thanks,
Tom
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
