-----Original Message----- ...A previous message on this list mentioned that "if you key the transmitter in CAL FIL mode, at least for an SSB FL1 filter, the signal is looped back to the receive side, through the filter". That could allow you a way to adjust the filter settings while listening to your own voice to see for yourself if it sounds bassy. --------------------------
I didn't know about that. When I adjusted my K2, I used a Drake 2B receiver to receive my own transmitted signal. I fed the audio from the Drake into my PC through a good sound card. I then transmitted with the K2 into a dummy load while I listened on the 2B. The recording showed me exactly what another person would have heard and I was able to fine tune my filter adjustment for my voice & mic. I then put the mic away and haven't used SSB since :-). Ah, life as a hopeless CW junkie! - Keith N1AS - - K2 5411.ssb.100 - - K3 Wave 3 - _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
