The AFSK mode has an undocumented INPUT filter limiting Line In signal from
800 to 1200 Hz. You can get a signal out in that range and you can set the
pitch to 915 MHz for receive. Unfortunately, invoking the Dual PB filter
inhibits transmission in AFSK, so you might as well use DATA A, where Dual
PB also doesn't work (stops all received signals).
The Line IN problem has apparently not been fixed, results remain
inconsistent. Another gotya is that having CWT on inhibits transmission.
Elecraft support says that these are all known problems.
Bob
KD8CGH
KX1, K2, K3
--
View this message in context:
http://www.nabble.com/AFSK-on-K3-tp14490402p14497064.html
Sent from the Elecraft mailing list archive at Nabble.com.
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
