Hello,
Also, once the boards are stuffed and the techs are not handling sensitive
components the ESD risk is greatly reduced. Once a device in soldered in the
board, the grounds from the chip to the board ground help a lot in reducing
the ESD problems.
However, some devices will work intermittently after being hit by static. It
can punch a hole in the FET and seem good, but fail down the road.
Best,
DW Holtman
WB7SSN
----- Original Message -----
From: "Jay Bromley" <[EMAIL PROTECTED]>
To: "John Klewer" <[EMAIL PROTECTED]>; <elecraft@mailman.qth.net>
Sent: Saturday, December 29, 2007 12:36 PM
Subject: Re: [Elecraft] K3 Technicians.....
I bet those blue mats under the rigs are anti static ones hooked up to a
ground bus of some sort?
73 de w5jay/jay..
And not an ESD wrist strap visible anywhere.....
[EMAIL PROTECTED] wrote:
Has anyone seen these pics yet:
_http://www.elecraft.com/K3/pics/_ (http://www.elecraft.com/K3/pics/)
Looks like Elecraft has at least 3 Techs working on getting those units
out! I wouldn't mind doing that
if they were in NC! It would be much cheaper for them to operate here:)
Looks like they are still in Production Run#1 though with the "orders
with deposits":(
Michael
N2ZDB
.com
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com