Have you run the Transmitter Gain calibration per the Owner's manual on all bands, first at 5 watts without the KPA3 enabled, then again at 50 watts with the KPA3 operating? (See Owner's manual, Calibration Procedures).
Ron AC7AC -----Original Message----- I have installed my Xmas present the KPA3 into K3 36 All seems to be OK apart from an error message, ERR TXG on the 30m band only. Other bands seem OK and acting as should. When trying to transmit into a dummy load 50Ohm I get no power out and hear a 200Hz or so whine coming from the rig. The manual says that usually indicates a problem with band-pass foilter alignment or one of the low pass filters. See Service manual. Anyone any ideas please. I guess elecraft tech help not available today. Thanks Rowland G4APO _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
