Mike,
Do it - it certainly will harm nothing even if it does not cure any problem.
It can be done without disassembling the front panel - remove the left
side panel, scrape a bit of the solder mask off the ground plane next to
the microphone jack and solder an 'L' shaped wire to both the mic jack
and the ground plane. It takes a lot of heat (and more time than a
normal connection) to make the solder flow, so use a higher temperature
on your soldering station or pull out the 'big gun' for this task
73,
Don W3FPR
Mike Walkington wrote:
Hi,
Just wondering what the definitive advice is on doing the K2 Microphone Jack
Grounding modification. I note there is no mention of doing this in either
the K2 or KSB2 manuals?
Mike
VK1KCK
K2 #2599
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
