Hi Gang,
Yesterday I posted about troubles following building a new 222
transverter. While probing TP5 in transmit I only had 3.5mV instead
of the normal range of .1 -10V. Today I checked all voltages listed
in the Owner's Manual and the only other voltage out of spec is that
the output of U1 on transmit goes to zero. It should be 3 - 6 V on
both xmit and rx.
I brought home from work a Tektronix 100MHz scope but the manual has
no RF voltages. Any ideas??
73,
Mark K2QO/R
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
