I'm not yet an owner of a K3, but I have been studying the schematic package
to learn as much as I can about the rig.
On the RF Board schematic, sheet 1 of 4, upper left border of the page is an
apparent multi-pin connector is labeled as "Z3 Stop-Band Filter." The next
sheet after all of the RF Board schematic sheets is a schematic called
"Bandstop Filter." I'm assuming this is the circuit that interfaces with
the Z3 connector. But I can't figure out how the Bandstop filter would
connect electrically to Z3!
Could someone educate me? Of course, that may be a lost cause! :-)
Thanks in advance!!
73,
Phil Westover, WA7URV (K1, K2, KX1, and a K3 not too far away!)
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
