Thanks Guys,
I must have missed that post!
Don
----- Original Message -----
From: "Dick Dievendorff" <[EMAIL PROTECTED]>
To: "'Don Wines'" <[EMAIL PROTECTED]>; <[email protected]>
Sent: Saturday, January 12, 2008 12:46 PM
Subject: RE: [Elecraft] New DSP Firmware won't Load
Please update your USB to Serial Adapter driver. There is a link to the
Prolific web site in the Troubleshooting section of K3 Utility Help.
73 de Dick, K6KR
-----Original Message-----
From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED] On Behalf Of Don Wines
Sent: Saturday, January 12, 2008 10:32 AM
To: [email protected]
Subject: [Elecraft] New DSP Firmware won't Load
I downloaded the new K3 utility this morning so I could upgrade the K3
firmware.
The MCU V1.58 loads OK but the DSP V1.48 won't load. The K3 VFO B area
tells
me "NEW K3UTIL SOFTWARE REQUIRED * * * *".
I have reloaded the K3 utility (V1.1.1.7) but the DSP still won't load. It
takes about 10 minutes for the attempt after which the K3 displays "E
000202" in VFO A and "ERR DSE" in VFO B. The manual tells me to reload the
DSP firmware which is what I have been trying to do.
I am using the Elecraft Serial/USB adapter cable.
I have also tried the "Cold Boot" method to no avail.
Is there any way to load older (working) versions of the firmware?
Don Wines
K5DW
K3 #123
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
